Open Access Open Access  Restricted Access Subscription Access

PROTECTION OF SINGLE PHASE INDUCTION MOTOR AND MONITORING

Aditya Narayan Sharma, Jaikaran Singh, Deepak Kumar, Rahul Rajawat, Vibhor Rastogi

Abstract


In this project we give a special idea of industrial automation, and fault monitoring. Induction motors are the nerves of many industries. Hence industrial automation is required for precise and accurate operation. The project Arduino based parameter monitoring system for induction motor proposes a control and monitoring system for induction motor based on Arduino communication protocol for safe and economic data communication in industrial fields. Current, voltage, and temperature of the induction motors are very important parameters for its control system. The performance of an induction motor is directly affected by these fundamental quantities. However, during continuous operation it is difficult to control the machines. Arduino system is used for collecting and storing data and generate control signal to start or stop the induction machine. We measure the different type of fault such as Over Voltage, Over Current and Over Temperature.


Full Text:

PDF

References


Javed A. and Izhar T., “An improved method for detection of faults in induction motor.” Third International Conference on ElectricalEngineering,2009,ICEE09,pp.1-6,9-11 April 2009,Lahore.

C.Grantham and D.McKinnon"Rapid Parameter Determination for Induction Motor Analysis and Control",IEEE TranscactionsOnIndustryApplications,Vol.39,no.4,pp.1014-1020,August 2003.

SudhaM. and AnbalganP., “A Novel Protecting Method for Induction Motor Against Fault to Voltage Unbalance and Single Phasing ,” 33rdAnnual Conference of the IEEE Industrial Electronics Society,2007,pp.1144-1148,5-8.

Dinesh Pai A, L Umanand, N J Rao "Direct torque control of induction motor with extended Kalmanfilter",IPEMC Power Electronics and Motion Control Conference,Vol.25,no.7,2000.

RamazanBayindir, Ibrahim Sefa, IlhamiColak, AslinBektas, “Fault Detection and Protection of Induction Motors Using Sensors,” IEEE Transactions on Energy Conversion, vol. 23, No. 3, September 2008.

Pillay P., Hofmann P. And Manyage. “Deratingof induction motors operating with the combination of unbalanced voltages and over or under voltages,” IEEE Transactions on Energy Conversion, Vol.17, no.4, pp.485=491, Dec.2002.

Nuno D. Simoes, Joao L. Goncalves, Maria L. Caeiro, Miguel J. Boavida, Fillipe D. Cardosco,a“Arduino/GPS Tracking System for Rowing Races,”aInternational Conference on Advances in Mobile Computing and Multimedia, Paris, France, Nov.2010.

S. Siddique, G.S. Yadhava, and B. Singh, “A review of stator fault monitoring techniques of induction motors,” IEEE Transactions on Energy Conversation, vol. 20, No. 1, pp-106-114, March 2005.

F. Filipetti, G. Franceschini, C. Tassoni, and P. Vas, “EAI techniques in induction machine diagnosis including the speed ripple effect,” IEEE Transactions India Applications, vol. 34, No. 1, pp.98-108, January/February 1998.

PetermutschlerDarmstatd University Of Technology Department Of Power Electronics And Drives:A New Speed Control Method For Induction Motors.

Faiz J., Ebrahimpour H. And PillayP.,“Influence of unbalanced voltage on steady state performance of a three phase squirrel cage induction motor,” IEEE Transactions Energy Conversion, Vol.19, no.4.pp.657- 662,dec.2004.


Refbacks

  • There are currently no refbacks.