Open Access
Subscription Access
Step up DC-DC converters for PV applications: A Review
Abstract
The demand for electricity has risen with the rapid increase in population leading to depletion of fossil fuels. Alternate sources of energy such as renewable sources of energy like wind, solar PV and fuel cell are being brought into use. Renewable sources like solar PV and fuel cell stack are operated at low voltage typically in the range of 20V-40V. For certain applications which require higher voltage such as grid -tied systems, it is required to boost up the voltage. In this paper classification of topologies and step up converters for the application of solar has been presented.
References
M. Das and V. Agarwal, “Design and Analysis of a High-Efficiency DC-DC Converter with Soft Switching Capability for Renewable Energy Applications Requiring High Voltage Gain,” IEEE Trans. Ind. Electron., vol. 63, no. 5, pp. 2936–2944, 2016.
M. Shen, F. Z. Peng, L. M. Tolbert, and S. Member, “Multilevel DC – DC Power Conversion,” vol. 23, no. 1, pp. 420–426, 2008.
A. I. Bratcu, I. Munteanu, S. Bacha, D. Picault, and B. Raison, “Cascaded DC – DC Converter Photovoltaic Systems : Power Optimization Issues,” vol. 58, no. 2, pp. 403–411, 2011.
H. Wang, J. Liu, and R. Wang, “Stability issue and corresponding design considerations in a system of cascaded bidirectional DC-DC converters,” PESC Rec. - IEEE Annu. Power Electron. Spec. Conf., pp. 2813–2818, 2008.
S. B. Kjaer, J. K. Pedersen, and F. Blaabjerg, “A review of single-phase grid-connected inverters for photovoltaic modules,” IEEE Trans. Ind. Appl., vol. 41, no. 5, pp. 1292–1306, 2005.
G. R. Walker et al., “Power-Electronic Systems for the Grid Integration of Renewable Energy Sources : A Survey,” IEEE Trans. Power Electron., vol. 53, no. 4, pp. 1002–1016, 2006.
J. Ferrieux and Y. Lembeye, “Optimization and Design of a Cascaded DC / DC Converter Devoted to Grid-Connected Photovoltaic Systems,” vol. 27, no. 4, pp. 2018–2027, 2018.
A. I. Bratcu, I. Munteanu, S. Bacha, D. Picault, and B. Raison, “Power optimization strategy for cascaded DC-DC converter architectures of photovoltaic modules,” Proc. IEEE Int. Conf. Ind. Technol., 2009.
P. Prakash, S. George, S. Eldo, and A. Raina, “Cascaded Boost Converter for PV Applications,” vol. 2, no. 4, pp. 1401–1406, 2014.
N. Naghizadeh and S. S. Williamson, “A comprehensive review of power electronic converter topologies to integrate photovoltaics (PV), AC grid, and electric vehicles,” 2013 IEEE Transp. Electrif. Conf. Expo Components, Syst. Power Electron. - From Technol. to Bus. Public Policy, ITEC 2013, 2013.
L. W. K. Lrgh, “A new configuration for multilevel converters with diode clamped topology,” Eng. Conf., pp. 661–665, 2007.
J. C. Rosas-Caro, J. M. Ramirez, and A. Valderrabano, “Voltage balancing in DC/DC Multilevel Boost Converters,” 40th North Am. Power Symp. NAPS2008, pp. 1–7, 2008.
Q. Zhao and F. C. Lee, “High-efficiency, high step-up dc-dc converters,” IEEE Trans. Power Electron., vol. 18, no. 1 I, pp. 65–73, 2003.
R. Guo, Z. Liang, and A. Q. Huang, “A High Efficiency Transformerless Step-up DC-DC Converter with High Voltage Gain for LED Backlighting Applications,” Twenty-Sixth Annu. IEEE Appl. Power Electron. Conf. Expo., pp. 1350–1356, 2011.
D. D. C. Lu and V. G. Agelidis, “Photovoltaic-battery-powered DC bus system for common portable electronic devices,” IEEE Trans. Power Electron., vol. 24, no. 3, pp. 849–855, 2009.
B. Sahu and G. A. Rincon-Mora, “A low voltage, dynamic, noninverting, synchronous buck-boost converter for portable applications,” IEEE Trans. Power Electron., vol. 19, no. 2, pp. 443–452, 2004.
M. A. Pagliosa, T. B. Lazzarin, R. G. Faust, and I. Barbi, “Input-series and output-series connected modular single-switch flyback converter operating in the discontinuous conduction mode,” IET Power Electron., vol. 9, no. 9, pp. 1962–1970, 2016.
N. H. Baharudin, T. Muhammad, N. Tunku, and F. A. Hamid, “Topologies of DC-DC Converter in Solar PV Applications,” Indones. J. Electr. Eng. Comput. Sci., vol. 8, no. 2, pp. 368–374, 2017.
P. Muthukrishnan and R. Dhanasekaran, “Dc-Dc Boost Converter for Solar Power Application,” J. Theor. Appl. Inf. Technol., vol. 31, no. 683, pp. 630–636, 2014.
T. A. Vu, D. P. Nam, and P. T. V. Huong, “Analysis and control design of transformerless high gain, high efficient buck-boost DC-DC converters,” IEEE Int. Conf. Sustain. Energy Technol. ICSET, pp. 72–77, 2017.
R. Saha, “Multiplier with High Gain DC-DC Converter,” 2017.
W. Li, X. Lv, Y. Deng, J. Liu, and X. He, “A review of non-isolated high step-up DC/DC converters in renewable energy applications,” Conf. Proc. - IEEE Appl. Power Electron. Conf. Expo. - APEC, vol. 2, pp. 364–369, 2009.
G. R. Walker and P. C. Sernia, “Cascaded DC-DC Converter Connection of Photovoltaic Modules,” IEEE Trans. Power Electron., vol. 19, no. 4, pp. 1130–1139, 2004.
F. J. C. Padilha, W. I. Suemitsu, and M. D. Bellar, “Transformerless DC-DC step-up topologies with symmetrical outputs for renewable energy applications,” Proc. - ISIE 2011 2011 IEEE Int. Symp. Ind. Electron., pp. 450–455, 2011.
J. Zeng, “A Single-Switch Isolated DC-DC Converter for Photovoltaic Systems,” pp. 3446–3452, 2012.
P. K. Maroti, M. S. B. Ranjana, and D. K. Prabhakar, “A novel high gain switched inductor multilevel buck-boost DC-DC converter for solar applications,” pp. 152–156, 2014.
M. S. B. Ranjana, N. Sreeramulareddy, and R. K. Pavan Kumar, “A novel sepic based dual output DC-DC converter for solar applications,” 2014 Power Energy Syst. Conf. Towar. Sustain. Energy, PESTSE 2014, no. Pestse, 2014.
R. Davis, “Developed Non-isolated High Step-up Converter with Low Voltage Stress,” pp. 1537–1540, 2016.
M. P. Shreelakshmi, M. Das, and V. Agarwal, “High gain, high efficiency bi-directional DC-DC converter for battery charging applications in stand-alone Photo-Voltaic systems,” 2013 IEEE 39th Photovolt. Spec. Conf., pp. 2857–2861, 2013.
Refbacks
- There are currently no refbacks.