Open Access Open Access  Restricted Access Subscription Access

Design and Implementation of Full Bridge Non-isolated DC-DC Bidirectional Converter Using Fuzzy logic

M.S. Kulkarni, Bhagyashri Rudragounda Patil, Saloni Arun Warake, Ankita Kalidas Bhandare, Nayan Vijay Patil, Priyanka Sanjay Shinde

Abstract


With ever increasing benefits of non-renewable energy sources, the importance of energy storage system is increasing consistently. Power electronics converters are usually used to convert the power from renewable sources to match the load demand and grid requirements to improve dynamic and steady state characteristics of these green generation systems. Therefore, there is growing importance in bidirectional DC to DC converters for interface battery with energy sources. As DC to DC bidirectional converters can transfer the power between two DC sources in either direction, these converters are widely used in renewable energy hybrid power systems. Efficiency, economy and high conversion ratio are the some challenges in the development of DC to DC converters. For the low voltage range, non-isolated DC to DC converters are suitable also; they are fit for DC micro grid voltage levels.

Full Text:

PDF

References


H. R. Karshenas, H. Daneshpajooh, A. Safaee, P. Jain, A. Bakhshai (May 2011), “Bidirectional DC-DC converters for energy Systems,” International Conference on Electrical Machines and Systems, pp. 161−178.

S. Waffler, J. W. Kolar (June 2009), “A novel low-loss modulation strategy

for high-power bi-directional buck + boost converters,” IEEE Trans. Power Electron, Volume 24, pp. 1589–1599.

D S. Dwari, L. Parsa (Jan 2011), “An efficient high-step-up interleaved DC-DC converter with a common active clamp,” IEEE Trans. Power Electron, Volume 26, Issue 1, pp. 66–78.

M. Kwon, W. Choi (Apr. 2014), “High gain soft-switching bidirectional DC–DC converter for eco-friendly vehicles,” IEEE Trans. Power Electron, Volume 29, Issue 4, pp. 1659–1666.

J.-S. Lai, D. J. Nelson (2007), “Energy Management Power Converters in Hybrid Electric and Fuel Cell Vehicles,” in Proc. of the IEEE, Volume 95, Issue 4, pp. 766−777.

M. A. Abdullah, H. M. Yatim, C. W. Tan, A. S. Samosir (2013), “Control of a bidirectional converter to interface ultracapacitor with renewable energy sources,” in Proc. of IEEE International Conference on Industrial Technology (ICIT 2013), Cape Town.

M. Y. Chong, A. A. Rahman, N. A. Aziz, A. Khamis, Shah Alam, (23-24

Page 15-21 © MAT Journals 2019. All Rights Reserved

Journal of Embedded Systems and Processing Volume 4 Issue 2

June 2010), “Performance comparison of bidirectional converter designs for renewable power generation,” in Proc. of 4th International Power Engineering and Optimization Conference (PEOCO 2010).

Inoue, S., Akagi, H (2007), “A bidirectional dc–dc converter for an energy storage system with galvanic isolation,” IEEE Trans. Power Electron, Volume 22, Issue 6, pp. 2299–2306.

Chen, L.R., Chu, N.Y., Wang, C.S., Liang, R.H. (2008), “Design of a reflex based bidirectional converter with the energy recovery function,” IEEE Trans. Ind. Electron., Volume 55, Issue 8, pp. 3022–3029.

Tsorng-Juu Liang, Jian-Hsieng Lee (July 2015), “Novel High-Conversion- Ratio High Efficiency Isolated Bidirectional DC–DC Converter,” IEEE Transaction on Industrial Electronicsc, Volume 62, Issue 7.

H. L. Do (September 2011), “Nonisolated Bidirectional Zero-Voltage-Switching DC–DC Converter,” IEEE Transactions on Power Electronics, Volume 26, pp. 2563−2569.

Wu TF, Chen YC, Yang JG, et al. (2010), “Isolated bidirectional full- bridge DC–DC converter with a flyback snubber,” IEEE Trans Power Electron, Volume 25, Issue 7, pp. 1915–1922.

Hyeonju Jeong, Minho Kwon, Sewan Choi (2017), A High Gain Non-isolated Soft-switching Bidirectional DC-DC Converter with PPS Control, IEEE.

Muhammad Mujtaba Asad, Razali Bin Hassan, Fahad Sherwani (2014), “An Analytical Comparison between Open Loop, PID and Fuzzy Logic Based DC-DC Boost Convertor,” International Scholarly and Scientific Research & Innovation Volume 8, Issue 11.

Pratapsinh G. Parmar, Urvashi D. Patel, Manish S. Patel (Feb. 2016), “Closed Loop Control of Bi-Directional DC-DC Converter”, IJIREEICE, Volume 4, Issue 2.

Wai, R.J., Duan, R.Y., Jheng, K.H. (2012), “High-efficiency bidirectional dc–dc

Converter with high-voltage gain,” IET Power Electron, Volume 5, Issue 2, pp. 173–184.


Refbacks

  • There are currently no refbacks.