Numerical Study of Heat Transfer through Fin by using ANSYS-Fluent Model

Basima S. Khalaf

Abstract


A mathematical model of the process occurring on fin at same height and different height with different heat flux (10000, 20000, 30000 w/m2) have been investigated. The model is developed using principles of heat transfer, fluid dynamics, and these values used for comparing with two height of fin which used in electronically device like computer. The distributions of velocity and temperature was found along flow path of fin cell using the software computer (ANSYS FLUENT 16.1), this software was developed to apply the theoretical model to simple three -dimensional geometry. Finally the optimal heat flux and temperature along fin has been obtained for five tests of fins, and a good agreement is found between theoretical results with previous works.

Full Text:

PDF

References


Deepener et al. (July 2011), “Theoretical analysis of gas turbine blade by finite element Method”, Scientific World, Volume, Issue 9.

SH Barhattcl et al. (January−March 2011) “Experimental and computational analysis and optimization of heat through Fig with different types of Notch”, Volume 2, Issue 1, pp. 133−138. E-Issn0976- 7916. JERS/.

Throng Nuan et al., “Crushing analysis and numerical optimization of angle

element structures unser axial impact loading”.

Bvenkatesh, V Kamalam, AMK Prasad (2010), “Modeling and analysis of aluminum A360 Alloy italic gear for Marine Applications”, Volume 1, Issue 2, ISSN-0976-3259.

P Ramamurthy Raju A et al. (2007), “Evaluation of Fatigued life of aluminum alloy wheels under radial loads”, Engineering Failure Analysis, Volume 14, pp. 791−800.

N Satya Narayana, P Ch Sambals (2012), “Fatigue analysis of Aluminum alloy wheel under Radial Load”, Volume 2, Issue 1, ISSN- NO. 2231-46779.

J Jonardhan, V Ravikumar, R Lili tha, Narayang (2014), “Radial fatigue analysis of anally wheel”, Decomposer, Volume 4, Issue 2, Part 6, pp. 253−258. ISSN-2248-96229.

H Hosseini- Toudeshky, B Mohammedia, G Sidechain, HR Dag hyena (2007), “Numerical and experimental Fatigue Crack growth analysis in mode- I for repaved aluminum panels using composite material”, Composites, Part A, Volume 38, pp. 1141−1148.

Kant ha K, Rao Jaya Hertha, K Rao (July 2015), “Heal insulation analysis of an aluminum honeycomb Sandwich structure”, Journal of Thermal

Engineering Yildiz Technical university Press, Volume 1, Issue 3, pp. 201−220, Research Article- JTEN- 2014- 15. Astute bull, Turkey.

Ganesh Raut, Anil Manjra, P Bhaskar (Dec 2013), “Analysis of multidisc cutch using FEA”, International Journal of Engineering Treads and Technology (IJETT), Volume 6, Issue 1, ISSN: 2231-5381.


Refbacks

  • There are currently no refbacks.