Analysis of Knock Detection in Single Cylinder DI- Diesel Engine

vaishali ahlawat


The motivation behind this paper is to distinguish the "thump" in Diesel motors which decay the motor execution antagonistically. The strategy presented in the present work recommends a recently created approach towards dissecting the vibration examination of diesel motors. The strategy depends on crucial relationship between the motor vibration design and the relative attributes of the ignition procedure in each or distinctive chambers. Thump in diesel motor is recognized by measuring the vibration created by the motor utilizing The DC-11 FFT analyzer with accelerometer. Thump in diesel motor is for the most part because of the motor miss .A diesel motor miss comes about because of at least one barrels when the fuel is not smoldering appropriately. Disgraceful fuel smoldering is brought on by Infusion framework issues which incorporate, Faulty injectors, stopped up fuel channels, wrong Injection timing, Low motor pressure, infusion framework spills, Air releases, defective infusion pump and so on. Motor miss causes quick burning with high weights producing a thunder or dull rattling solid. Unusually boisterous sound with vicious vibration is called "thumping or explosion". Motor barrel vibration in FFT frame is observed at each stack the chamber excitation frequencies are contrasted and the gauge frequencies utilizing diesel oil. Time wave frames on the barrel head are likewise recorded to break down the ignition. Since the very ignition in the barrel is the essential exciter, the vibration investigation of the motor chamber through the deliberate FFT and time waveforms are the delegates of ignition affinity. Vibration accelerometer is mounted on the barrel head, ideally on the jolt interfacing the head and the chamber to record the motor vibrations utilizing DC-11 information lumberjack which straightforwardly gives the otherworldly information as FFT, the general vibration levels. This FFT information recorded is gathered by On-Time window based programming outlined by e-anticipate Inc., Argentina. The Time waveforms are acquired on the chamber head by DC-11 in the OFF-ROUT mode and are displayed in realistic frame by Vast DOS-based programming, composed by VAST, Inc., Russia. 

Full Text:



Leppard, W. R. Singular chamber thump event and force in multi barrel motor, SAE Technical Paper, N°820074, 1982

G. Brecq1 and O. 2 Le Corre "Demonstrating of In-barrel Pressure Oscillations under Knocking Conditions: Introduction to Pressure Envelope Curve .SAE2005

Draper, C.S. The physical Effect of Detonation in a shut barrel shaped chamber, Technical Report 493, NACA, 1935.

G. A. Karim, S. R. Klat and N. P. W. Moore, Knock in double fuel motors. Proc. Inst. Mech. Engrs 181, 453466 (1967).

ZiangAihua" "Blame Diagnosis on Misfiring of Engine with Vibration Signal" world logical e procedures 2008.

Jenkins S.H., "Investigation and treatment of diesel motor clamor", Journal of Sound and Vibration Vol .43(2), pp 293-304, (1975).

NwaforO.M.I., "Thump qualities of double fuel burning in diesel motors utilizing regular gas as essential fuel", Department of Mechanical Engineering, Federal University of Technology, Vol. 27, Part 3, pp.375-382, (2002).

WangYing, Zhou, Longbao. Examination of the discovery of thump and failure to fire of a start motor with the ionic current technique. Procedures of the Institution of Mechanical Engineers. 2003(7):617-621

'Gideon Goldwine, Gal deBotton, Boris Rivin and EranSher,"Assesment of the nature of burning in pressure start motor through vibration signature investigation Fista world car congress, Barcelona2004

"Condition Monitoring of a Small Four-stroke Petrol Engine utilizing Vibration Signals. SongponKlinchaeamKMITL Sci. Tech. J. Vol. 9 No. 1 Jan. - Jun. 2009.

K. Gschweitl, E. Gotthard, and A. Kampitsch. Constant thump investigation for programmed motor mapping and Calibration. SAE 942399, 1994.


  • There are currently no refbacks.