Open Access Open Access  Restricted Access Subscription Access

Deep Drawing Process and Finite Element Modeling: A Review

Mr. Aniruddh Shukla, Dr. Dharmendra Tyagi

Abstract


The work presents the use of Finite Element simulation along with Taguchi technique to define the impact of three significant process parameters in the deep-drawing process, namely velocity of punch, blank holder pressure and coefficient of friction.

Full Text:

PDF

References


Amit. D. Madake, Vinayak R. Naik, Swapnil S. Kulkarni 2013; development of a sheet-metal component with a forming die using CAE software tools (Hyper form) for design validation and improvement; international journal of Morden engineering research(IJMER)

Abdullah A. Dhaiban2014; Finite element modelling and experimental results of brass elliptic cups using a new deep drawing process through conical dies, Journal of Materials Processing Technology

Mohsen Hassan, Labib Hezam, Mohamed El-Sebaie, Judha Purbolaksono 2014; Deep drawing characteristics of square cups through conical dies,11th International Conference on Technology of Plasticity, Nagoya Congress Center, Nagoya, Japan

Hakim S. Sultan Aljibori, 2009; Finite element Analysis of sheet metal forming process; European journal of scientific research;

Ajay Kumar choubey, Geeta Agnihotri, C.Sasikumar; 2015; Numerical validation of experimental result in deep drawing; 4th international conference on materials processing and characterization.

Rashmi Dwivedi, Geeta Agnihotri; 2015; Numerical simulation of aluminium and brass material cups in deep drawing process; 4th international conference on material processing and characterization

T. Yagami, K. Manabe , Y. Yamauchi;2007;Effect of alternating blank holder motion of drawing and wrinkle elimination on deep draw ability journal of material processing technology,

A. Wifi, A.Mosallam ;2007; some aspects of blank-holder force schemes in deep drawing process; Journal of achievements in materials and manufacturing engineering; volume 24 issue 1,

Anupam Agrawal, N. Venkata Reddy, P.M. Dixit;2007; Determination of optimum process parameters for wrinkle free products in deep drawing process ;journal of material processing technology ;

Hasan Ali Hatipoglu; 2007; thesis on experimental and numerical investigation of sheet metal hydroforming process; graduate school of natural and applied science of middle east technical university.


Refbacks

  • There are currently no refbacks.