Open Access Open Access  Restricted Access Subscription Access

Thermal Analysis of a Large Shaft in Housing for Shrink Fitting Used in SPM Tools – A FEM approach

Raja Yateesh Yadav, Avinash H S, Suhas H C, Prafull Kumar H A


In this paper, a brief thermal evaluation of a huge shaft in housing for decrease fitting which is widely used in special reason device gear is carried out. Work is accomplished in 3 phase. Within the first section required interference among the shaft and the bore of the housing to face up to torque is decided. The interference is required to allow the casting and the shaft to rotate together without any slip and usage of bolt clamping. For enabling the decrease-match assembly of the bore and shaft, it's far required to extend the bore to a favored temperature by using software of external warmth supply. The bore is to be heated such that there is enough growth of the bore for an ease operating clearance. This clearance is needed after a length of forty five minutes from start line of cooling. These forty five minutes of time is needed for assembly method of the shaft into the bore. Within the very last segment, the brief thermal analysis of the housing is performed wherein the bore initially at a temperature of a hundred and fifty °C cools right down to a temperature of fiftyºC after a term of 45 mins elapsed.

Thermal Analysis of a Large Shaft in Housing for Shrink Fitting Used in SPM Tools – A FEM approach

Full Text:



T Videnic and F Kosel (2009) A shrink-fit problem between an eccentric and a solid of hollow shaft annulus ICBS Vol II pp 25-28

Fahrettin ozturk and Tse-Chien Woo (2005) Simulations of Interference and Interfacial Pressure for Three Disk Shrink-Fit Assembly 24th International conference on Advances in Mechanical Systems, pp 185-188

J D Booker, C E Truman, S Wittig and Z Mohammed (2008) A comparison of shrink-fit holding torque using probabilistic micromechanical and experimental approaches, International Journal on Advances in Material, 85(6), pp 29-35

C E Truman, A Sackfield and D A Hills Torsion loading of a finite shrink-fit shaft, Department of Mechanical Engineering, University of Bristol, UK

W.Kim, C. M. Lee and Y. K. Hwang A Study on the Shrink-Fits and Internal Clearance Variation for Ball Bearing of Machine Tool using FEM, Proceedings of the International Multi Conference of Engineers and Computer Scientists 2009 Vol III pp85-92


  • There are currently no refbacks.