Open Access Open Access  Restricted Access Subscription Access

The Machining qualities in EDM procedure of EN-8 amalgam metal with copper and aluminum as apparatus Cathode

Engr.Md.Rafiq Rahman

Abstract


Electric release machining (EDM) has been recognized as a proficient generation strategy for exactness machining of electrically leading solidified materials. Copper and aluminum are utilized as cathode substances on this method with Kerosene oil in light of the fact that the dielectric medium. the lead of copper and aluminum cathodes on electric release machining of EN-eight compound metallic had been considered. keeping up all extraordinary machining parameters same, the solidified canvases material changed into machined with the two anodes at uncommon estimations of top cutting edge, beat on time and obligation calculate as indicated by 23 full factorial design. it's been found that copper recommends higher results than aluminum in day and age of surface complete (µm) in same dielectric media. thus, copper is prescribed as an awesome anode material.


Full Text:

PDF

References


Jilani, S.T., Pandey, percent., Experimental research into the performance of water as Dielectric in EDM (1984), international journal of gadget tool layout and studies, 24,pp. 31-43.

Lonardo, P.M., Bruzzone, A.A., effect of Flushing and Electrode cloth on Die Sinking EDM. (1999), Annals of CIRP, forty eight, p.p 123-126.

Puertas, I, Luis, C.J., Alvarez, L., evaluation of the impact of EDM parameters on floor pleasant, MRR and EW of WC–Co (2004), journal of materials Processing technology, 123, p.p. 1026-1032.

Kansal, H.okay., Singh, S., Kumar, P., Parametric optimization of powder mixed electric discharge machining with the aid of response floor methodology (2005), magazine of substances Processing era, 169, p.p. 427-436.

Khan, A.A., Saifuddin, S.E., wear characteristics of Copper and Aluminum Electrodes during EDM of stainless-steel and Carbide (2005), Bangladesh, international conference on Mechanical Engineering.

Amorim, F.L., Weingaertner, W.L., The conduct of Graphite and Copper Electrodes at the finish Die-Sinking electric Discharge Machining (EDM) of AISI P20 tool metallic (2007), journal of the Brazil Society of Mechanical technology & Engineering. four, p.p. 366-371.

Tebni, W., Boujelbene, M., Bayraktar, E., Salem, E.B., Parametric technique version for figuring out electrical Discharge Machining (EDM) conditions: impact of cutting Parameters on the floor Integrity (2009), The Arabian journal for technology and Engineering, 34, p.p. a hundred and one-114.

Prabhu, S., Vinayagam, B.okay., effect of Graphite Electrode material on EDM of AISI D2 device steel with Multiwall Carbon Nanotube using Regression evaluation (2009), international journal of Engineering research, 1, p.p. 93–104.

Kumara, S., Singh, R., Singh, T.P., Sethi, B.L., floor change through electric discharge machining: A assessment (2009), magazine of substances Processing generation, 209, p.p. 3675–3687.


Refbacks

  • There are currently no refbacks.