Open Access Open Access  Restricted Access Subscription Access

To Investigate the Effect of Tensile Strength Welding Using Thin Mild Steel Sheets

Mr. Vijay Sahu, Mr. Tanmay Awasthi, Mr. Tanmay Awasthi

Abstract


Welding of thin sheets is additional complicated than thick sheets, as to organize over the heat input is mainly essential in thin sheets. Usual GTAW provides advanced heat input which in turn leads to various weld defects. In this investigation, welding has been performed for steel plate by varying different welding parameters. Welding is performed first by taking the effect of welding current and then the produce of welding speed has been measured. Effect of welding speed and welding current on the tensile strength of the weld joint has been investigated for both type of weld joint. In this paper, it is clear that the increase in current, tensile strength of the weld joint increases. In this paper, we also investigate the effect of grain growth on the tensile strength.

Full Text:

PDF

References


Amuda MOH, Mridha S (2011), “Analysis of sensitization profile in medium chromium ferritic stainless steel (FSS) welds”, International Journal of Integrated Engineering, Volume 3, Issue 1, pp. 17−22.

Bhajantri, A.H, Chate, G.R, Shiva kumar S, Nikhil R (2015), “Robust design approach to set the process parameters of TIG welding”, Advanced Engineering and Applied Sciences: An International Journal, Volume 5, Issue 3, pp. 46−52.

Chern, TS, Tseng, KH, Tsai, HL

(2011), “Study of the characteristics of duplex stainless steel activated tungsten inert gas welds”, Materials and Design, Volume 32, pp. 255–263.

Durgutlu, A. (2004), “Experimental investigation of the effect of hydrogen in argon as a shielding gas on TIG welding of austenitic stainless steel”, Materials and Design, Volume 25, pp. 19–23.

Gadewar, S.P., Swaminadhan, P., Harkare, M.G, Gawande, S.H (2010), “Experimental investigations of Weld characteristics for a Single pass tig welding with SS304”, International Journal of Engineering Science and Technology, Volume 2, Issue 8, pp. 3676−3686.

Hussain, A.K, Lateef, A., Javed, M., Pramesh. T (2010), “Influence of Welding Speed on Tensile Strength of Welded Joint in TIG Welding Process”, International Journal of Applied Engineering Research, Volume 1, Issue 3.


Refbacks

  • There are currently no refbacks.