On High Temperature Materials: Basic Deformation and Fracture Maps of AISI 310S Stainless Steel Sheet Taken from Production Runs of Salem Steel Plant (Steel Authority of India Limited, Ministry of Steel, Government of India) by Solving Various Equations Describing Different Mechanisms via Turbo C++ Language (Computer Software Programming)

Dr. A. Kanni Raj

Abstract


This research article models creep deformation and fracture of AISI 310S alloy. A programme coded in Turbo C++ is used to plot deformation maps and fracture maps. It is inferred that in all test temperatures (973K, 1023K and 1073K) and all applied stresses (40-150MPa), power-law creep due to dislocation climb is operating mechanism of creep deformation. In these test temperatures and applied loads, formation of voids and cracks at grain boundary, and leading to inter-granular creep fracture is evident. Metallographs prove these predictions.


Full Text:

PDF

References


Rishiraj (2018), Flow and fracture at high temperature, ASM International, Metals Park, USA

A.Kanniraj (2013), On High-Temperature Materials: A Case on Creep and Oxidation of a Fully Austenitic Heat-Resistant Super-alloy Stainless Steel Sheet, Journal of Materials, 2013, Article ID 124649, 6 pages, doi:10.1155/2013/124649

M.E.Kassner, and M.T.Perez Prado (2000), Five-power-law creep in single phase metals and alloys, Progress in Materials Science, 45, 1–102.

N.Bano, A.K.Koul, and M.Nganbe (2014), A deformation mechanism map for the 1.23Cr-1.2Mo-0.26V rotor steel and its verification using neural networks, Metallurgical and Materials Transactions A, 45, 1928–1936

S.N.Monteiro, L.P.M.Brandão, A.D.S.Paula, C.N.Elias, A.C.Pereira, F.S.D.Assis, L.H.D.Almeida, and L.S. AraUjo (2017), Creep fracture mechanisms and maps in AISI type 316 austenitic stainless steels from distinct origins, Materials Research. 20, 892-898

K.Maruyama, H.G.Armaki, and K.Yoshimi (2007), Multi-region analysis of creep rupture data of 316 stainless steel, International Journal of Pressure Vessels and Piping, 84, 171–176

R. Voicu, J. Lacaze, E. Andrieu, D. Poquillon, and J. Furtado (2009), Creep and tensile behavior of austenitic Fe-Cr-Ni stainless steels, Materials Science and Engineering, 510A-511A, 185–189.

H. DeCicco, M.I.Luppo, H.Raffaeli, J.DiGaetano, L.M.Gribaudo, and J.O.Garcia (2005), Creep behavior of an A286 type stainless steel, Materials Characterization, 55, 97–105


Refbacks

  • There are currently no refbacks.