Open Access Open Access  Restricted Access Subscription Access

Modeling and Simulation of Five-Phase Induction Motor Fed With Pulse Width Modulated Five-Phase Multilevel Voltage Source Inverter Topologies

Candidus. U. Eya, Gerald. C. Diyoke

Abstract


This paper presents modelling and simulation of five-phase induction motor fed with pulse width modulated five-phase multilevel voltage source inverter. The conventional and diode clamped multilevel five-phase inverter configurations are reviewed with pulse width modulation (PWM) techniques. A hybrid three-level inverter topology with less number of components count is proposed for five-phase induction motor drive. The dynamic analysis of five-phase voltage equations in d-q axis of the induction motor are stated and modelled using
Matlab/Simulink/Simscape blocks. The simulation results based on conventional and threelevel five-phase inverters are displayed while the hybrid inverter topology showed some better performance based on the following: : at 0.0127secs maximum torque of 34.54Nm occurred, maximum stator current occurred for 0.18secs with a value of 10A, 9.99% total harmonic distortion was obtained and 15KW power rating was obtained.


Full Text:

PDF

References


Sharma P., Kurwale M., Barve G.(2015),“Modeling of Inverter Fed Five Phase Induction Motor using V/f control Technique,” International Journal of Current Engineering and Technology.Volume 5, Issue 3, pp.1789-1793.

S.Dwari. L. Parsa.(2011), “Fault–tolerant control of five–phase permanent–magnet motors with trapezoidal back EMF ,”IEEE Transactions on Industrial Electronics, volume 58, no. 2, 2011, pp.

–485.

F. Locment, E. Semail, X.Kestelyn.(2008), “Vectorial Approach–Based Control of a Seven–Phase Axial Flux Machine Designed for Fault

Operation,” IEEE Transactions on Industrial Electronics, volume. 55, Issue.10, pp. 3682–3691.

J.R. Fu, T.A. Lipo.(1994), “Disturbance free operation of a multiphase current regulated motor drive with an opened phase,” IEEE Transactions on Industry Applications, vol. 30, Issue 5, pp. 1267–1274.

A. Tani, M. Mengoni, L. Zarri, G. Serra,D. Casadei.(2011), “Control of Multi–Phase Induction Motors with an Odd Number of Phases Under Open–Circuit Phase Faults,” IEEE Transactions on Power Electronics, DOI:

1109/TPEL.2011.2140334.

L. Parsa and H.A. Toliyat.(2007), “Faulttolerant interior-permanent magnet machines for hybrid electric vehicle applications,” IEEE Trans. on Vehicular Technology, Volume 56, Issue. 4.

Sharma P. G., Rangari S.(2013), “Simulation of Inverter Fed Five Phase

Induction Motor,” International Journal of Science and Research (IJSR), Volume 2,issue. 2, pp. 127-132.

H. Guzmán, M.J. Durán, F. Barrero.(2012) , “A Comprehensive Fault Analysis of a Five-Phase Induction Motor Drive with an Open Phase,” 15th International Power Electronics and Motion Control Conference, EPE-PEMC ECCE Europe,Novi Sad, Serbia.

H. Guzmán, J.A. Riveros, M.J. Durán, F.O.Barrero.(2012), “Modeling of a Five-Phase Induction Motor Drive with a Faulty Phase,”15th International Power Electronics and Motion Control Conference, EPE-PEMC ECCE Europe,Novi Sad, Serbia.

Aher K. S., Thosar A. G.(2016),“Modeling and Simulation of Five phase Induction Motor using MATLAB/Simulink,” Int. Journal of

Engineering Research and Applications,Volume 6, Issue 5, pp. 01-08.

E. Levi, R. Bojoi, F. Profumo, H. Toliyat,S. Williamson. (2007), “Multiphase induction motor drives–a technology status review,” IET Electric Power Applications, Volume 1, Issue 4, pp. 489–516.

E. Levi. (2008), “Multiphase Electric Machine for Variable Speed

Applications,” IEEE Transactions on Industrial Electronics Volume 55, issue 5,pp. 1893–1909.

Loriya V. J., Patel R. A. (2016),“Performance Analysis of Five-Phase and Three-Phase Induction Machines,”International Journal of Innovative

Research in Electrical, Electronic,Instrumentation and control Engineering.

Volume 4, Issue 1, pp. 77 – 82.

Vinchurkar S. R., Pothi P. A. (2015),“Comparison between Three Phase and Five Phase Induction Motor by using Converter,” International Journal on Recent and Innovation Trends in Computing and Communication, Volume,Issue. 7, pp. 5007-5013.

Astik M. B. (2015), “Dynamic Modelling and Simulation of Five phase Induction Motor,” International Journal of AdvancedResearch in Electrical, Electronics and Instrumentation Engineering. Vol. 4, Issue 4,pp. 1998-2005.


Refbacks

  • There are currently no refbacks.